Make a 10by 15cm (4by 6inch) borderless copy of a
For the best quality when copying a photo, load photo paper in the input tray and
change your copy settings for the correct paper type and photo enhancement. You
might also want to use the photo print cartridge for superior print quality. With the tri-
color and photo print cartridges installed, you have a six-ink system. See
Use a photo
for more information.
In order to make a borderless copy, you must have photo paper (or
other specialty paper) loaded. If the HP all-in-one detects plain paper in the
input tray, it will not make a borderless copy. Instead, your copy will have
Load 10 by 15 cm (4 by 6 inch) photo paper in the input tray.
If your HP all-in-one has more than one input tray, you might need to select
the correct input tray. See
Select an input tray for copying
Load your original photo face down on the right front corner of the glass.
Position the photo on the glass so the long edge of the photo is along the front
edge of the glass.
Start Copy Color
The HP all-in-one makes a 10 by 15 cm (4 by 6 inch) borderless copy of your
original photo, as shown below.
If the output is not borderless, then set the paper size to
, set the paper type to
, set the
enhancement, and then try again.
For more information on setting the paper size, see
Set the copy paper size
For information on setting the paper type, see
Set the copy paper type
For information on setting the
Enhance light areas
of your copy